Quick Start Guide for setting up your TOWNEW T1

Quick Start Guide for setting up your TOWNEW T1

Jun 02 , 2021

Omar Abdalla

Important safety instruction


- For indoor use only. If you want to put TOWNEW T1 under a desk or sink, please make sure that there is a 35cm distance above TOWNEW T1 and a 10cm distance besides TOWNEW T1 so that the lid sensor won't be triggered and keep the lid open all the time.

- Do not place near a heat source, rinse it, or soak it in water. Here's how to clean your TOWNEW T1

- Do not close the lid manually with your hand. In Auto-sensing mode, the lid will be closed after your hand is removed from the sensor zone. In Open-lid mode, touch the button once to close the lid.

- Do not use an unauthorized battery and power adaptor.

- Do not put too much trash.

- During sealing, do not open the lid.

- Turn off the power if TOWNEW T1 is not used for a long time. Leaving your TOWNEW T1 until it's running out of battery may damage the battery.

For more details, please read the printed user manual.

     

    After unboxing, make sure to fully charge your TOWNEW T1 for 10 hours. For maintenance, it is highly recommended to charge your TOWNEW T1 once a week to prevent the battery to be out-of-power because the battery can be damaged when it's drained.

    Product introduction

    Setting up your TOWNEW T1 

    Turn on your TOWNEW T1 and then install the refill ring as shown below.
    That’s it! Your TOWNEW T1 is now ready for use.

    Knowledge , T1
    Newer Post